Redgard Epoxy Deep Penetrating Sealer

painting, waterproofing, polyurea, repainting, reflective coating, exterior wall waterproofing, self-levelling epoxy, ceramic coating, water-based epoxy coating, water-repellent coating

REDGARD DPS

REDGARD EPOXY DEEP PENETRATING SEALER (DPS) is a two-component clear epoxy coating especially formulated for waterproofing and concrete sealer applications. It has exceptionally low viscosity property that enables it to seep through concrete surface porosity providing an effective first line barrier against intrusion of water and other liquids. Its excellent adhesive, flexibility and chemical resistance properties will provide the user years of trouble-free protection.

  • As a standalone protective sealer for concrete and neutral mineral substrates such as bricks, natural stones, pavers, precast concrete and cement fiberboards.

  • As a waterproofing primer which is a vital part of Elastomeric waterproofing System for concrete gutters, roof decks, toilet & bath firewalls and other similar concrete structures. REDGARD DPS helps promotes adhesive of the waterproofing paint to the concrete substrates and penetrates deeply providing an effective first line barrier against intrusion of water.

  • Avoid contact with skin and eyes, and avoid breathing its vapor.
  • Work areas must be adequately ventilated.
  • Keep containers properly closed and store in a cool dry place.

SURFACE PREPARATION

All existing dirt and other surface contaminants adhering on the surface must be thoroughly removed. Apply Concrete Neutralizer using sufficient coats to completely neutralize the surface. Do not wash off. When sufficiently dry, dust lightly to remove crystalline deposits.

MIXING & APPLICATION 

Mix thoroughly by volume 1 part of resin to 1 part of hardener. Any change from the recommended proportion will affect its quality. Scrape the bottoms, sides and corners of the container to ensure complete and full blending. Prepare only enough quantities than can be used within the pot-life period. Do not delay application. Apply REDGARD DPS by brush or roller or by using an airless spray. Allow to cure overnight prior application of topcoat.

ADHESION 100% Retention (ASTM D3359) - Excellent to concrete and wood
CHEMICAL RESISTANCE Highly resistance to exposure to fumes, most acids, salts, alkalis
VISCOSITY 15 seconds #4 FC
MIX RATIO 1 part epoxy resin to 1 part hardener by volume
POT LIFE 2 hours
DRYING TIME Set to touch in 30 minutes, to recoat in 1 - 2 hours
CURE TIME Initial cure after 24 hours, full cure 3 - 4 days
THEORETICAL COVERAGE 22 - 24 sq. meters per gallon set depending on the porosity of the surface
No. OF COATS REQUIRED 1 coat if to be used as primer, 2 - 3 coats if to be used as a protective sealer
FINISH Gloss
PACKING Gallon set